Drain Port

IMPORTANT!

IF THE OIL LEVEL IS TOO HIGH THE HEAT WILL NOT BE DISSIPATING QUICKLY ENOUGH

AND THE TEMPERATURE OF THE HYDRAULIC SYSTEM WILL RISE.

IF THE OIL LEVEL IS

TOO LOW

IT MAY CAUSE CAVITATION*.

• To drain the oil, tip unit back, place an empty container that can hold at least 1 Gallon (4 Liters) of oil under the

log splitter.

• Use an Allen Wrench [P/N 520516 (8mm)] and remove Drain Port Plug and the seal in the aluminum bottom cover plate

of the log splitter.

• Hold the handle, move unit up a little and position it under the angle. Using an Adjustable Wrench, unscrew the Dipstick

and open the Oil Fill Port to let air in and help the oil flow out. Wait until the oil completely escapes from the oil reservoir.

• Reinstall the Drain Port Plug and the seal. Be careful not to damage the threads of the Aluminum Bottom Cover.

• After the used oil is drained, pour approximately 0.83 of a gallon (3.15 liters) of recommended oil into the Oil Fill Port.

• Clean the Dipstick and insert it to check the oil level; it should be between the two notches on the stem. If level is low,

add recommended type of the hydraulic oil. If the level is too high, pour out a little at a time into a container.

*Reference: Cavitation occurs when the volume of hydraulic fluid demanded by any part of a hydraulic circuit exceeds the volume

of fluid being supplied. If there is an air bubble in the system, the force applied gets used compressing the air in the bubble rather

than moving the piston. This affects the efficiency of the system. In this case, Force (Rated 5 tons) will be cut down.

• Reinstall the Dipstick and the seal. Be careful not to damage the threads of the Dipstick Plug and Aluminum

Top Cover.

• Clean thoroughly.

• Loosen air bleed screw, turn 3 to 4 times.

• Purge air from the hydraulic system by cycling the pressure plate back and forth 3 to 4 times.

WARNING

DUMPING USED HYDRAULIC OIL IN THE ENVIRONMENT IS FORBIDDEN. THE FLUID

MUST BE DISPOSED IN ACCORDANCE WITH THE LOCAL ENVIRONMENTAL RULES

AND PROCEDURES.

WARNING

BEFORE PERFORMING ANY MAINTENANCE BE SURE THAT:

• LOG SPLITTER IS DISCONNECTED FROM POWER SOURCE.

• PUSHER PLATE IS FULLY RETRACTED (RETURNED TO THE LOWEST POSITION)

AND NO RESIDUAL HYDRAULIC ENERGY IS LEFT IN THE SYSTEM.

• OIL HAS COOLED.

J. Sharpening the wedge

Sharpen the splitting wedge, as needed, using a fine-toothed file to remove any burrs, nicks or flat spots from the wedge.

Oil Fill Port

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21

Comentários a estes Manuais

Sem comentários

Sharp FO 4400 - B/W Laser - All-in-One manuals

Owner’s manuals and user’s guides for Copiers Sharp FO 4400 - B/W Laser - All-in-One.
We providing 1 pdf manuals Sharp FO 4400 - B/W Laser - All-in-One for download free by document types: Specifications

Sharp FO 4400 - B/W Laser - All-in-One Specifications (144 pages)

Brand: Sharp | Category: Copiers | Size: 5.44 MB |

FACSIMILE

Introduction

Important safety information

Table of Contents

A Look at the Operation Panel

Middle panel (Rapid Key pad)

Lower panel

1. Installation

Important!

Attaching the ADF exit tray

Verification Stamp option

1. Installation

Loading Printing Paper

• To enter a space, press

• To change case, press

Setting the Date and Time

Daylight Saving Time

Volume Adjustment

2. Sending Documents

Maximum scanning area

Other restrictions

Loading the Document

Resolution

Contrast

• Press and/or to

Programming Auto-Dial Numbers

Editing auto-dial numbers

Clearing auto-dial numbers

Dual Access

Rapid Key Dialing

Speed Dialing

Direct Keypad Dialing

Chain Dialing

If the memory becomes full

2. Sending

Documents

4: MESSAGE CLEAR

ENTER MESSAGE #

Display:

Memory Retransmission

Automatic redialing

PERSONAL

Using a personal book

Closing a book

Clearing a book

Cover Sheet

COVER SHEET

Batch Page Numbering

3. Receiving Documents

Using MANUAL Reception Mode

MEM.STATUS

4. Making Copies

• Copying will begin

5. Special Functions

Storing numbers in Group Keys

Editing a group

Confidential Operations

Confidential reception

Clearing a passcode

Polling others

Being polled (Memory polling)

Clearing a document

Polling Security

06:ID # MODE

1=SET, 2=CLEAR

1:ID CODE # SET

ENTER # (1-5)

Timer Operations

Transmission

Confidential transmission

Serial Polling

Broadcasting

Canceling a timer operation

Batch Transmission

Entering and Using Programs

Batch transmission

Being Polled (Memory polling)

Clearing a Program Key

Using a Program Key

DUPLEX SCAN

Print Hold

Clearing the Print Hold code

Printing received faxes

Accessing the machine

100

5. Special

101

Functions

101

Telephone Billing

102

Department Control

102

Distinctive Ring

104

6. Optional Settings

106

♦ Initial setting: 1

107

♦ Initial setting: 0 (off)

107

♦ Initial setting: 2

107

♦ Initial setting: 5

108

♦ Initial setting: 02

108

♦ Initial setting: 05

108

♦ Initial setting: 10

110

♦ Initial setting: 4

113

♦ Initial setting: 2 (NO)

114

Activity Report (List 01)

115

Line Error

116

Problems and Solutions

116

Printing Lists and Reports

117

Personal Book List (List 11)

118

Activity Report

119

8. Maintenance

120

8. Maintenance

121

9. Troubleshooting

122

Transmittable Documents

125

Connections

127

Clearing Paper Jams

127

Confidential

127

Operations

127

Audible signals

128

• Caution!

130

FCC Regulatory Information

132

S H A R P

133

QUICK REFERENCE GUIDE

136

GUÍA DE CONSULTA RÁPIDA

137

GUIDE DE RÉFÉRENCE RAPIDE

138

1-800-BE-SHARP

144

More products and manuals for Copiers Sharp

Models	Document Type
AR-163	Specifications Sharp AR-163 Specifications [en] , 80 pages
AR-M700	User Manual AR-M550, AR-M620 and AR-M700 Series Brochure - G, 12 pages
AR-162S	User Manual AR-M162 Specification Sheet - CXS, 2 pages
SF-1014	Service Manual Sharp SF-1014 Service manual, 153 pages
AR-M316	Service Manual Sharp AR-M316 Service manual, 159 pages
AL-1250 - B/W Laser Printer	Specifications Sharp AL-1250 - B/W Laser Printer Specifications, 51 pages
AR-CF2	Service Manual Sharp AR-CF2 Service manual, 42 pages
MX-M620U	Specifications Sharp MX-M620U Specifications, 200 pages
AR-F14N	User Manual SHARP TROUBLE & ERROR CODES AR-M256, AR, 12 pages
AR-155N	Specifications Sharp AR-155N Specifications, 56 pages
FO-781	Instruction Manual Sharp FO-781 Instruction manual, 208 pages
AR-5220	Specifications Sharp AR-5220 Specifications, 19 pages
AR-NB2N	User Manual AR-168S & AR-168D Brochure - CXS, 4 pages
AR-162S	Specifications Sharp AR-162S Specifications, 68 pages
Z-26	User Manual Инструкция по эксплуатации Sharp Z-26, 32 pages
SF-2040	User Manual Инструкция по эксплуатации Sharp SF-2040, 95 pages
Z-21	User Manual Инструкция по эксплуатации Sharp Z-21, 31 pages
SF-2314	User Manual Инструкция по эксплуатации Sharp SF-2314, 43 pages
AR-161	User Manual Инструкция по эксплуатации Sharp AR-161, 80 pages
AR-163	User Manual Инструкция по эксплуатации Sharp AR-163, 82 pages

Mantis Swift Split Manual do Utilizador Página 15

Comentários a estes Manuais

Sharp FO 4400 - B/W Laser - All-in-One manuals

Sharp FO 4400 - B/W Laser - All-in-One Specifications (144 pages)

Table of contents

More products and manuals for Copiers Sharp

Mantis Swift Split Manual do Utilizador Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Rachadores de lenha Mantis Swift Split

Sharp FO 4400 - B/W Laser - All-in-One manuals

Sharp FO 4400 - B/W Laser - All-in-One Specifications (144 pages)

Table of contents

More products and manuals for Copiers Sharp